|
Display Frame Instructions
Installing your Display Frame
Mounting your display frame is fast and easy! Whether you choose to mount it
on a wood or masonry wall, or hang them from a partition, all the hardware you
need is included.
Installation Instructions
for Hanging Frames on Walls:
|
- Snap open all sides of the frame and remove the start
up poster.
- Place the frame against the wall in the position desired
and mark the wall with a pencil through the four holes
located near the corners. On hollow walls, place the
frame against the wall in the desired position with the
picture hangers on the back of the frame extended.
Mark the wall with a pencil through each opening.
- Mount frame.
On masonry walls: Using 1/4" masonry bit, drill four holes 11/4"
deep into the wall at the points marked. Insert the plastic anchors
and tap them in. Attach the frame to the wall using 11/4" screws
and spacers.
On wooden walls: Using a 3/32" drill bit, drill four holes 3/4" deep
into the wall at the points attached. Attach the frame to the wall
using the 11/4" screws and spacers.
On hollow walls: Hammer picture hooks into the wall with the nails provided. Hang the
frame by placing the hangers on the hooks.
Note: The frames also include "D Rings" which can be used with standard picture hooks to hang the frames.
|
|
 |
Installation Instructions for Hanging Frames over Partitions:
- Determine the width of the partition on which you.d like to hang the frame. From the provided
plastic partition hangers, choose the small extender for partitions up to 113/16" (5 cm.); choose
the large extender for partitions up to 21/2" (7 cm.).
- Holding the hook in one hand with the holes at the top, slide the long extender shaft
perpendicularly down through the guides at the end of the hook.
- Lock the extender into the desired position by pushing the prongs into the appropriate holes.
- Test the completed hanger on your partition and make any necessary adjustments.
- You may use the white protective pads between the hanger and the partition.
 |
To Change Materials in your Remote Display Frame
- Snap open each of the four sides of the frame.
- Pull out existing poster.
- Insert new poster into frame and snap the top side shut.
- Snap remaining three sides shut.
Note: For easy storage of posters, load entire month of posters into frame with earliest in front.
When you want to display the next poster, pull out the first poster to display the next poster in line.
|
|
Download PDF version of this page.
|
